Jks OGS651 Manual do Utilizador descarregar pdf

JKSOGS651 JKS XJ Shackle Installation

1 Page

INSTALLATION

INSTRUCTIONS

Product: XJ Shackles

Part Number: JKSOGS651

517-278-1226 • [email protected] • www.jksmfg.com

491 W. Gareld Avenue, Coldwater, MI 49036

Welcome

CONGRATULATIONS on purchasing a set of XJ

Shackles from JKS Manufacturing. We are committed

to providing you with the best products available and

your satisfaction is our rst priority.

PLEASE READ these Installation Instructions careful-

ly, and save them for future reference, as they contain

important installation and maintenance information.

Important

REFER TO FACTORY SERVICE MANUAL for

information and procedures not covered in these

instructions.

Tools Required

 Metric/Standard Socket Wrench Set

 Torque Wrench

 Grease Gun with Zerk Fitting Coupler

 Wheel Bearing Grease

 Hydraulic Floor Jack & Jack Stands

 Factory Service Manual (recommended)

* Asterisk denotes tools that are not required for some ap-

plications. Thoroughly read instructions rst to determine

which tools will be required for your application.

Installation

 1. REMOVE ORIGINAL SHACKLES

 Raise and support vehicle chassis with jack

stands positioned in front of the leaf springs.

 Raise and support the axle housing with a

hydraulic jack to relieve the axle weight.

 Remove spring shackle hardware from leaf

spring and chassis, and remove shackle from

vehicle. Retain the original mounting hard-

ware.

 2. PRE-LUBRICATE XJ SHACKLES

 Apply a thin layer of wheel bearing grease to

surface of Bushing Sleeve and Polyurethane

Bushings.

 Assemble Sleeve and Bushings in XJ Shack-

les.

 3. INSTALL XJ SHACKLES

 Position XJ Shackles in the original location

with the JKS decal facing forward (front of

vehicle) to ensure correct operation and maxi-

mum suspension travel.

 Mount XJ Shackle to leaf spring and chassis

with original hardware, but DO NOT tighten

mounting bolts.

 4. TIGHTEN MOUNTING HARDWARE

 Once both XJ Shackles have been installed,

lower the vehicle to the ground until leaf

springs are supporting full weight of vehicle.

 Using a torque wrench, tighten the mounting

hardware to factory torque specications for

your vehicle.

 5. POST-INSTALLATION

INSTRUCTIONS

 Lubricate grease zerk ttings on XJ Shack-

les immediately after installation using wheel

bearing grease or equivalent.

 After driving vehicle 50 miles, lubricate and

re-torque mounting hardware.

Maintenance

XJ Shackles should be lubricated regularly as part of

vehicle maintenance schedule.

Regular cleaning with pressurized water is recom-

mended to maximize ease of operation and reliability.

Always lubricate afterwards to evacuate any moisture.

Revision Date 11/1/2013

INSTALLATION 1
INSTRUCTIONS 1

Resumo do Conteúdo

Página 1 - INSTRUCTIONS

JKSOGS651 JKS XJ Shackle Installation1 PageINSTALLATIONINSTRUCTIONSProduct: XJ ShacklesPart Number: JKSOGS651517-278-1226 • [email protected] • www.jksm

Comentários a estes Manuais

Sem comentários

Jks OGS651 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Para o carro Jks OGS651. JKS OGS651 User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Para o carro Jks OGS651